A study on the fluid film of an atomization-based cutting fluid (ACF) spray system during titanium machining

Hoyne, Alexander

Permalink

https://hdl.handle.net/2142/44183 Copy

Description

Title

A study on the fluid film of an atomization-based cutting fluid (ACF) spray system during titanium machining

Author(s)

Hoyne, Alexander

Issue Date

2013-05-24T21:53:36Z

Director of Research (if dissertation) or Advisor (if thesis)

Kapoor, Shiv G.

Department of Study

Mechanical Sci & Engineering

Discipline

Mechanical Engineering

Degree Granting Institution

University of Illinois at Urbana-Champaign

Degree Name

M.S.

Degree Level

Thesis

Keyword(s)

• Machining
• cutting fluid
• atomized droplets
• film formation
• modeling
• titanium machining
• temperature measurement
• fluid film penetration
• cooling and lubrication.

Abstract

The poor thermal conductivity and low elongation–to–break ratio of titanium lead to the development of extreme temperatures localized in the tool–chip interface during machining of its alloys and cause accelerated tool wear. The atomization–based cutting fluid (ACF) spray system has recently been demonstrated to improve tool life during titanium machining. The penetration into the tool–chip interface by means of the thin fluid film created by the ACF spray system appears to be the mechanism by which tool life is extended. However, there is a lack of a physics-based understanding of the development of the fluid film created by the ACF spray system and its resulting cooling and lubrication properties during titanium machining. The research presented in this thesis characterizes the development of the fluid film created the ACF spray system and investigates the resulting changes in cutting temperatures and friction inside the tool–chip interface during titanium machining. To accomplish this, ACF spray experiments are performed in order to observe the nature of the spreading film, while titanium machining experiments are performed to determine the temperature reduction inside the tool-chip interface, respectively. A physics-based model of the fluid film development is proposed in order to predict the thickness and velocity of the fluid film and study the tool-chip interface fluid penetration behavior. On the experimental front, ACF spray experiments are performed by varying impingement angle in order to observe the nature of the spreading film and to determine the film thickness at different locations after impingement of the droplets. It is observed that the film spreads radially outward producing three fluid film development zones (i.e. impingement, steady, unsteady). The steady zone is found to be between 3 and 7 mm from the focus (impingement point) of the ACF spray for the set of parameters investigated. Fluid film penetration of the tool-chip interface is observed during titanium machining. The temperature gradient and mean cutting temperature are also measured using the inserted and the tool–work thermocouple techniques, respectively, during titanium machining with the application of the ACF spray system. Cutting temperatures for dry machining and machining with flood cooling are also characterized for comparison with the ACF spray system temperature data. Findings reveal that the ACF spray system more effectively reduces cutting temperatures over flood cooling. The tool–chip friction coefficient data indicate that the fluid film created by the ACF spray system also actively penetrates the tool–chip interface to enhance lubrication during titanium machining, especially as the tool wears. On the modeling front, an analytical three-dimensional (3D) thin fluid film model for the ACF spray system has been developed based on the continuity equations for mass and momentum. The model requires a unique treatment of the cross–film velocity profile, droplet impingement and pressure distributions, as well as a strong gas–liquid shear interaction. The analytical film model is validated via a comparison of the predicted and experimentally measured fluid film thickness profiles. The model predictions of film velocity also reveal that the fluid film created by the ACF spray system can readily penetrate into the entire tool–chip interface during titanium machining.

Graduation Semester

2013-05

Permalink

http://hdl.handle.net/2142/44183

Copyright and License Information

Copyright 2013 Alexander Hoyne

Owning Collections